I have an m50tu that's bone stock, just did a head gasket and intake manifold refresh on. So far it drives fine when you're cruising but as soon as you go full throttle, it starts to misfire consistently. After I cause it to misfire , it will then occasionally miss when driving normally.
I tried running it with the MAF unplugged to see what would happen, and found out that shortly after starting to drive, it started to misfire all the time.
Any thoughts and recommendations are welcome.
Sent from my CPH2451 using Tapatalk
Was the head decked and checked for cracks?
Attn. NEWBIES: Use the search feature, 98% has already been discussed.
Click the search button, select "search single content type", select the "e36 sub forum" specifically, try the "search titles" then try the "search entire posts".
Check all your electrical connections and the grounds for the coils.
Attn. NEWBIES: Use the search feature, 98% has already been discussed.
Click the search button, select "search single content type", select the "e36 sub forum" specifically, try the "search titles" then try the "search entire posts".
Bookmarks