|
some of you are having issues with the pnp connectors so i thought i'd clear it up here for all to see.
your pnp connector comes with 4 wires:
brown(double wire) = ground
yellow = low beam
white = high beam
grey = angel eyes/city lights
start by doing your install, connect the angel eyes to your parking lights (grey/yellow stripe on one side, grey/purple on the other).
install your hid's(if equipped), mount the ballast in your bumper support using good quality double sided tape.
last you will need to properly connect the pin end of the plug and play to your headlights, first find your ground(brown) connect it to one of the pins in the back of the headlight and then proceed to find the correct pin for the highs and angel eyes, this may take a few tries as the ground pin may be any one of the 4, once you have everything figured out and working repeat the same steps for the second headlight, don't assume the pin configuration to be same, it probably isn't.
|