A while back I was going to swap the clutch out on my 93 for a 95m3 clutch. I was told by the creeps at Curry's Auto in Chantilly Va that my "clutch was about to go". So I went out and aquired the parts I needed, 120k miles later I still have them unused as my clutch was not about to go and with 161k miles it still works just as good as 6 years ago.

I have the following.
1 complete used 95 m3 flywheel with the complete clutch assembly.
1 new complete BMW Dealer clutch kit.
New fork, and a few other parts too that they said I needed for the conversion.

$600 for the whole setup or best offer.

Also fs is an e36 92-94 power steering pump ($50), and an e36 92-99 steering rack ($100).

Will post pics later.
PM me, don't try and email me the email address on my user doesn't work.

I also have. E36 m3 stainless steel brake lines never installed bought from TMS.
Its a kit of 4 lines.

Peake Research code tool, the one that reads codes and resets the oil lights.

A used set of M3 suspension front struts with springs and bearings. Struts are pretty well done and need to be replaced but the springs and bering plates are good.

A set of adjustable camber plates.

lightly used m3 front brake pads. You can have these if you come get the rotors.

Used set of cross drilled rotors.

e36 bentley manual

Possibly Bilstein rear shocks with H&R lowering springs. I got these with the front struts several years ago and never got around to putting them on.

PM Me to make an offer.
No low ball offers though.

Also brand new in the box water pump.
Brand new m3 exhaust hanger brackets.

how much for the flywheel and the new clutch kit? pm me plz thanks.