so I got my lights installed and every ring is bright except the drivers side high beam ring. Everything is hardwired but that one halo remains dim. I switched the leads on the inverter but those same leads lit up the low beam halo great so the problem must be with the ring? Could I just have a bad ccfl tube? I am so fustrated and just have all the halos off until I fix it

turned them on again.....now both high beam halos are dim.....


what could the problem be? i havent even driven anywhere with them, but i think i am going to just return the lights
i dont have time right now trying to figure out stupid CCFL crap
i am not an idiot and wired everything fine, and there are NO loose connections

Have you tried checking with the car running?

Have you tried checking with the car running?

yep

Is it cold outside? Soldering all the connections will help, instead of using the pin connectors, etc.