I have an E36 BD kit (I beleive it's for a 95 325). The ducts themselves fit in the fog light ports but are a tiny bit smaller in height than the port on my M3. I assume this is because the M3 fogs are larger?

I bought these from Turbo Mike not knowing the were for a car that still has the wheel well covers in. My car is a stripped racer.

I will sell the this for $120.00 plus shipping.

Here are the some pictures

bump

I'm looking for these for my e36, my car has the wheel well liners and from the pictures it looks as though there is a flange that attaches to the liner. My question is where are the other brackets in the picture attached? I'm pretty sure they are attached to the brake backing plate, does it require modification / removal of the backing plate?

I'm looking for these for my e36, my car has the wheel well liners and from the pictures it looks as though there is a flange that attaches to the liner. My question is where are the other brackets in the picture attached? I'm pretty sure they are attached to the brake backing plate, does it require modification / removal of the backing plate?

If you want backing plates then you have to remove the OEM. Turner and bimmerworld seel, the backing plates.
The one bracket does attatch to the liner. The other I have no idea where it attaches. It came with the kit.

Hope this helps

Bruce

This kit is a steal for $120. It mates the JTD kit and the Bimmerworld kit minus the backing plates. You can keep the factory brake ducts effectively doubling the cooling to the rotors/pads.

I just built this kit on my e36 m3 and it was much more expensive.

Check the JTD and Bimmerworld site for pics of where the components belong on the car.

And to checkerboard6, none of the components attach to the backing plate.

Hope this helps the buyer and seller.

Yes, it's a good deal. All I got to use for my $400.00 was the backing plates. They're CF and go for 250.00. With the open whell well I could not use any hose included. I needed a 2.5' pc per side. So for 120.00 you get 200.00 worth of stuff.

Thanks for the bump

Bruce

up

any pics with this installed? i want to see the gap.

Sold,
Thank you everyone.