|
View Full Version : front pitman arm removal trouble cerizoman1 03-20-2008, 07:47 PM I am replacing drive link and cant get the pitman arm to let go....using a pitman arm removal tool and it just wont give...any thoughts....i got the oter side free but this one is a bugger...hammering and using the tool and nothing...help!!! thanks, michael plik 03-20-2008, 07:49 PM This is from backinblack98, "4. If you have trouble getting the pitman arm and idler arm off of the centerlink and are changing out the centerlink, you can actual disconnect the idler arm from the frame - which is quite easy, disconnect the pitman arm from the steering gearbox and snake the whole thing through and out the driver side. obviously you will have to turn the idler arm parallel to the centerlink & tie rod ends. Then you can easily pop them off using that tool in the pic above in the bottom left. IMPORTANT Make sure to mark the pitman arm and gear to indicate where it needs to line backup on installation." Here is a link, http://forums.bimmerforums.com/forum/showthread.php?t=956982&highlight=pitman+arm What removal tool are you using? http://www.bimmerboard.com/members/stygian7/front%20end%20service%20kit.jpg cerizoman1 03-20-2008, 07:50 PM using one i got from napa.....1 1/8 pitman arm removal cerizoman1 03-20-2008, 07:51 PM i am replacing the center link as the inner tie rod is bad on drivers side...have everyting else ready just cant get this one on driverside loose.... cerizoman1 03-20-2008, 07:55 PM thanks plik, i will try that! cerizoman1 03-21-2008, 12:10 AM it worked! thanks plik, i removed it and then used a fork and beat the heck out of it as i could drive to get the tool, back together now and going to for alignment tomorrow backinblack98 03-21-2008, 09:30 AM it worked! thanks plik, i removed it and then used a fork and beat the heck out of it as i could drive to get the tool, back together now and going to for alignment tomorrow It is so much easier that way isnt it? The just isn't enough room or leverage to get the tool in there to pop it off. Glad things worked out well for you! Car will feel great after your alignment. :redspot plik 03-21-2008, 12:08 PM it worked! thanks plik, i removed it and then used a fork and beat the heck out of it as i could drive to get the tool, back together now and going to for alignment tomorrow I'm glad it worked. :) Don't thank me, though; thank backinblack98. I just copied what he wrote in another thread. http://www.sydneykidscommittee.org.au/images/photos/butthead.jpg |