Since i need to kit these, and now that I can take pics i thought i would put some idea of what they are. They are intended for marine use and have no choke.

There is a little wand that shoots a spurt of gas every time you push the throttle all the way down. I also learned after spending 100 buck on the kits that the kit consisted of a 4 dollar jet, a 2 dollar holley diaphragm, and one gasket that I could have easily made myself. The good news is that all of the screws and fittings are brass and the seals are brass as well instead of being rubber.

http://i150.photobucket.com/albums/s83/jonathon1979/DSC00137.jpg

this is the top view

http://i150.photobucket.com/albums/s83/jonathon1979/DSC00138.jpg

this is the side view, the fuel mixture computer is indicated by the red arrow

http://i150.photobucket.com/albums/s83/jonathon1979/DSC00139.jpg

front view of air cleaner manifold

http://i150.photobucket.com/albums/s83/jonathon1979/DSC00140.jpg

insert four dollar holley diaphragm here

http://i150.photobucket.com/albums/s83/jonathon1979/DSC00141.jpg

view of float bowl from bottem, and bottom case from top. the brass valve on bottom case is a one way valve that is channeled to the wand at the back of the carb.

http://i150.photobucket.com/albums/s83/jonathon1979/DSC00142.jpg

back view of carb without the air cleaner on, this is the wand i mentioned.

thats it i hope the pics were not to big.

hey, i saw those on ebay a while ago. have you ran them on a car? they look cool

have you been to strictlyea.com? its a texas euro car forum that has alot bmw guys.

have you been to strictlyea.com? its a texas euro car forum that has alot bmw guys.

sounds great ill check it out, and yes i did run them until seeing all the gaskets were hardened