I'd like to know if there is a "secret" method to remove the two bolts that hold the fron calipers on. The bolts require a 18mm socket. I tried to loosen these bolts with my 580 ft lb air ratchet and they woulf not budge. Since I don'nt have a lift, I have to work off a jack and stand. This makes using a 3/4 breaker bar and extension impossible.

wow there on tight. how about turning the wheel all the way to one side and using a break bar? thats what i had to use.

Not to be rude but make sure you are turning them the correct way. They are lefty loosey but facing the wrong way so double check. I use a 1/2" impact and never had a problem.

Oh ya, Did you take the caliper off that bracket yet? There are two allens under some plastic caps.

yea i was gonna ask him u were turning em the right way since they are reversed. but didnt want to since u do have air tools hah.

wow. i cant believe they are on that tight. your prob going to have to use a breaker bar. just hitting it wit a impact will break the bolt eventually

I did make sure a few times that I was turning them in the correct direction. I would have used a breaker bar, but since I was working on a jack, I had no room to get any swing on the bar. Thanks all for the info.