I've been missing a pc of my l/r headrest since I got the car. PO's didn't complete their raping of the interior. So the only one I could find was black. I went to the local AutoMat, a big auto upholsterer here on LI. I asked him about dyeing it or reskinning it. He suggested I bypass both, dyeing being messy and time consuming, reskinning being way expensive (approx $150). He suggested I use an adhesive base and flexible coating made for plastics, leather, glass, just about anything man made. They themselves use it. He called up the road to a big paint shop and off I went. I ended up with these 2 products, Bulldog adhesive spray and SEMS flexible coating. After cleaning the pc w/ a brillo pad and drying I started w/ the base coats. This is some NASTY stuff. Use a respirator for sure! Don't even think of smoking in the same room! 2 coats approx 10 min apart. 30 min to dry up hard. Then spray on the flexible coating lightly spraying. A couple coats of that and a couple hrs to dry up completely and good to go! It's expensive stuff, the adhesive is $19 and the flex coating $10, but I think well worth it.....oh and I finally found my map light and got the cigarette lighter working!

and the end result!!

What do those buttons do in the dash above the map light? Usually the heated seat buttons are there, but why two buttons in each location?

i think for hi heat and lo heat. 2 each for each seat

sixseries is right !