Up for sale is my Megasquirt MS v3 PCB with MS-II CPU wired to an S50 harness.
Pretty much plug and play, hardwire into your car, plug into your engine. Coil on plug, tune was solid at 15psi. Comes with boost cut and antilag.
800.00

would the harness work on an obd1 m52? Im still running all of the original wiring from my old m50

It should are you using the crank position sensor, or hall?

so is this a complete plug and play for a 95 m3 obd1?

You have to do a little wiring on your end (powers, grounds, wideband etc) But yeah the harness will plug into and is setup for an S50 OBD1.

Open to offers

What kind of power were you making with this set up?

Can you send me a pic of the harness set up and inside of the MS?

Was this a kit or did you buy it built?

I can get pics, it was around 400hp, and it was built by Urinemachine

Will it fit a m50b25 obd1? If so im really interseded. please send me some pics.

Bump

700 shipped

700 shippedWhat size turbo were you using with the antilag?

So... I have this spare S50, and an E30 just lying around... :shifty

It was T3 60-1 .70/.81ar


What size turbo were you using with the antilag?

why are you selling?

why are you selling?

I sold my engine, turbo ect..

It was T3 60-1 .70/.81arGoing from an S50 with a T-60 to an S38 with...? or is that a secret :D

Not 100% sure yet, I'm at about 98%

No longer for sale.