So i closed my sunroof the other day and it sort of got stuck between positions..????...Now when I close it it sits down abit in the back to the roofline..Any ideas??:(

Is it dead or working normal now as far as all positions? Does it seem like it's traveling full cycle mechanically when closed? How much too low? abit=?
some humor- it reminds me of Bill Cosby as Noah with the "cubits" for the arc!

Is it dead or working normal now as far as all positions? Does it seem like it's traveling full cycle mechanically when closed? How much too low? abit=?
some humor- it reminds me of Bill Cosby as Noah with the "cubits" for the arc!No it works fine but now sits about an 1/8 inch low in the back=abit.:lol

..just needs to have the 6 torx screws adjusted so that it sits level again. More likely than not, the carrier arms have snapped at the screw locations. Not expensive, just time consuming...

..just needs to have the 6 torx screws adjusted so that it sits level again. More likely than not, the carrier arms have snapped at the screw locations. Not expensive, just time consuming...Do I need to drop the headliner to adjust it??? The roof operates the way it should..I went to open it the other day when it was nice out and it opened like it was getting stuck ,so I closed it and it opened again fine but now sits about 1/8 inch low in the back but still operates fine both ways..Thanks for the help TxGR8White..:)
Mark

Courtesy E31faq:
Raise the sunroof and feel behind floating liner for the long metal rods running
parallel to the side edges. Push these outwards gently to disengage the clips and allowing you to push the floating panel backwards until you can see all three torx bolts on either side of metal sunroof panel mount. Loosen them and adjust as necessary.:redspot

Courtesy E31faq:
Raise the sunroof and feel behind floating liner for the long metal rods running

parallel to the side edges. Push these outwards gently to disengage the clips and allowing you to push the floating panel backwards until you can see all three torx bolts on either side of metal sunroof panel mount. Loosen them and adjust as necessary.:redspot

Thank You SSC...........Mark