I recently purchased these angel eyes from an online retailer and they seem like the wrong parts. First pics show ballast connectors on left and harness on right. Seems like wrong connectors.


http://i186.photobucket.com/albums/x110/havik253/wires001.jpg

They also came with the clips on the wires already.( diy shows putting on after fishing through rubber boot)
What do you think guys?

http://i186.photobucket.com/albums/x110/havik253/wires002.jpg

looks like everything is there? got better pics?

you got the right kit and all the right parts.
your kit includes 4 brass bullets that slip over the pins (first pic) since 90%+ lose, misplace or otherwise toss them you can splice, solder and heat shrink the connection.

the rings for your car are totally different then any other kit, the pin connectors are installed at the factory, if you read and look at the diy you'd notice these difference in the pre 2004 kits, having the pin connectors on the rings does not change the ease or the install in general.
the diy guide is for pre 04 coupes BTW, other then the pins and the preinstalled connectors on the rings the install is exactly the same.

you got the right kit and all the right parts.
your kit includes 4 brass bullets that slip over the pins (first pic) since 90%+ lose, misplace or otherwise toss them you can splice, solder and heat shrink the connection.

the rings for your car are totally different then any other kit, the pin connectors are installed at the factory, if you read and look at the diy you'd notice these difference in the pre 2004 kits, having the pin connectors on the rings does not change the ease or the install in general.
the diy guide is for pre 04 coupes BTW, other then the pins and the preinstalled connectors on the rings the install is exactly the same.
I did not receive any "brass bullets" with my kit.