After Thanksgiving... say the week following?


Anyone want to get dirty??? :rolleyes


I will buy lunch!!! :D :buttrock (or beer, if we do not do it on base) :redspot

if at the hobby shop i am down to help you out. i need to take my car there anyways to change my guibo. after work? or you taking leave?

I am on leave now. I will be back after the 25th.

i may be TDY 27 - 29/30 Nov. so i may not be able to help out. crap.

Well... I do not have to do it that week... I prefer to start this project with an experienced set of eyes... :)

How about after you come back, we figure it out???

i will let you know.

i do know that i learned a lot when i did my tranny and flywheel. i learned that we did some things on brandons that i think we should not have and kyle taught me a few short cuts too. one thing we definetely need though is locktite red, new bolts, and the torque specs. oh and do you have a centering tool?

Got specs, centering tool, new bolts (for flywheel), will purchase loctite... Any special tools or other things I need?

hmmm no not really. a really long extension to get the bell housing bolts off. i have impact sockets but since we are using base tools... nothing comes to mind. its pretty straight forward. loosen motor mount nuts (or take them off) - drive shaft off - disconnect shift linkage - tranny mounts off - bell housing bolts off - pull tranny - etc.