***NEW PRICES 12/10 !!!***


Need to get rid of some things that have just been sitting in the garage. I am going a *slightly* different direction with my car. Would rather sell to someone here than eBay.

GReddy eManage Ultimate with MAP sensor, USB interaction cable, and GReddy wiring lead for a wideband O2 sensor. Loaded with most recent firmware from GReddy. CDrom included. MAP sensor connector has a piece missing, but still connects fine. I have it secured with a zip tie just in case. Universal wiring harness included. I also have a custom injector resistor box needed to install on an OBD II e36. NEW PRICE 399 shipped! SSSSSSSOOOOOOOOOOOOOOOOOLLLLLLLLLLLLLDDDDDDDDDDDD! !!!!!!!!!!!!!


RMS discharge tube for cars with ASC. Drilled and tapped for water/alky injection. I went to a front mount, so I have no need for this any more. I DO have the couplers that go with it. 75 shipped. LOWERED TO 60 SHIPPED.

http://i76.photobucket.com/albums/j40/turbosporttsi/Parts/DSC01275.jpg


2.87" S/C pulley. Looks to be for a Powerdyne. 50 shipped. LOWERED TO 45 SHIPPED.

J&S Safeguard knock controller with sensor. Used on Dinan cars. I got this from another board member, and have not used it... probably will never get around to it anyway. It looks to have most everything it needs. Worst case, you might have to make a few wires. 60 shipped. REDUCED TO 50 SHIPPED OBO! (EDIT: just found out that this wil not work with COP ignitions. This particular unit is geared more towards e30's, etc.)

I can provide additional pics via email upon request. Thanks! :buttrock turbosporttsi at hotmail dot com

Will trade for 3.5" HFM or other random goodies. PM with offers.

Chris paypal'd you $6 + shipping for the RMS silicone S/C coupler. Thanx for the deal!

Wes

any way you can measure what the inner bore is of the supercharger pulley where it presses onto the supercharger?

Got it, Wes. Thanks.

rs4pro3-I can eyeball it with my tape measure.... I do not have calipers to take an accurate reading. Are you wanting to know depth or diameter?

I need to know the diameter of the pulley where it slides onto the supercharger shaft(trying to determine if it will fit on a different brand supercharger)

sorry for the delay. The diameter of the hole looks to be about 25/32". Just bigger than 3/4".

dang too big, I need something closer to 5/8" Thanks for checking

Bump for new parts.

ttt

S/C pulley sold. Thanks, David.

Can you send pics of the Knock sensor stuff and the harnesses to gotm3@aol.com

Thanks

As soon as I get back from vacation, I will get those to you, as I have no pics on hand. :) Happy Holidays everyone.

interested. email pics to lbalicha@hotmail.com or just post them. thx

Those are the only pics I have available to me at the moment.

e36widelip- I'm diggin the wheels, man. What are they?

Thanks Chris

Any time kobe.

Bump for added pics!

bump.

Bump for very reduced prices. Someone pick these up.

Another bump for even MORE reduced prices....