i found out that my auto came with a 4.xx not the 3.91. This will be much too high.

Anything within 3.4x-3.9x should be fine.

open for trades also :)

Ryan

Where's that MS write up?:shifty

I was watching a 3.91LSD on ebay, someone used Buy It now, went for $250 then $85 shipping. There's also a 3.64 on there right now. http://cgi.ebay.com/ebaymotors/BMW-E32-735i-limited-slip-diff-3-64-lsd-E34-5-series_W0QQitemZ220163037079QQihZ012QQcategoryZ337 31QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

MS...... Anatomy practical exam :(

Thanks for the links though.

3.64 is nice for around town - gives you tons of grunt and 'quickness'. Kills your highway RPM's tho.

I've got a 3.91 open I'll sell for $150 + shipping.

is it 4.27?

I have a 3.63 in the garge I will trade for yours.

earl, is that an LSD? Mine is. Do you want a straight up trade then?

What is your actual gearing? Mine is missing the speedometer sender, one of the bolt holes for the sender is stripped and needs to be tapped (very easy) and the front yoke is off. The yoke that is with it should fit an automatic drive shaft.

Mine is 4.27 LSD. Did you take the front flange off? You do know they are preloaded from the factory, right? How is the thread stripped (bad, very bad, next size up)

yes, I know about the preloaded flange/yoke. regardless, the yoke/flange is off of, that one. And I would guess that the strip is the next size up. The screw, seemed to come out normal. But When I looked at the screw, the treads seemed to packed with metal. I then looked at the hole, and it looked slightly larger than the other and smooth. How much does it cost to ship?

3.64 is nice for around town - gives you tons of grunt and 'quickness'. Kills your highway RPM's tho.

Some of us have OD transmissions;)

should be 40-50. Don't forget to drain it though. So are you up for a trade. I have other things you may be interested in too ;)

Also, is it open or LSD?

its LSD, what else do you have?

I have lots of things. I've got a remote mount oil filter setup for the m30, pioneer 5x7 i had mounted in the rear, Pioneer 12" 600w sub (cant recall model), Pioneer DHP-350, M30 intake manifold, M30 Slightly over bored throttle body, M50 OBD1 manifold, Lots of Megasquirt stuff, etc....

I'd still be up for a diff trade though. Since i would be bringing it in to a shop to do the work could i send a deposit so you could send out the diff and i will return mine to you when it is out?

I have a 3.46 limited slip sitting in the garage. If you want it, cut me a deal on a MS2+wasted spark setup and it's yours.

Also have a 3.23 open.

let me figure out how to ship it, and i will get back to you with my address

We will see, in this game the lower number wins. If lowel comes through i would like the 3.46.

I have a 3.46 limited slip sitting in the garage. If you want it, cut me a deal on a MS2+wasted spark setup and it's yours.

Also have a 3.23 open.

How much are you asking for the 3.46 if Goatthumper doesn't want it? I have a 3.73ls in transit, but am really happy with the stock 3.46 ratio and just want a LS unit?

Thanks

goat i got a 3.91 out of a 89 535i auto i believe its open $100 PLUS SHIPPING IT YOURS IM IN JERSEY

Well Goat let me know if you want to do it, i was doing it becuse it we were doing a swap no $ involved except for shiping