attbimmer
08-28-2007, 04:59 PM
I need to roll the rear fenders on my E36 M3 to fit 17x9 LTWs. Does anyone have a fender rolling tool in or near Orange County (I'm in Tustin) that i could borrow/rent? I'd like to use a tool rather than just going at it with a hammer. I also don't really want to just pay a shop to do it since i might need to do it again in the future when i change to coil overs. I might end up just buying the tool, but thought i'd check to see if someone already had one near by. Thanks in advance.