UPDATE: NEW PICS BELOW


DLS Up35 3-way components -- SOLD


DLS A7 Ultimate 5 channel amp. "The Big Five" -- SOLD !!!

BSW deck mounted single 12" box w/ IDQ sub -- SOLD !!!

http://www.we-todd-did-racing.com/thumbs/large/1049079_whjh3/endofconversation.jpg (http://www.we-todd-did-racing.com/view/full/1049079_whjh3)

Forgot to mention, the only trade i'd be willing to take is for a DSLR camera, depending on condition and accessories.

Preliminary Bump....

.(....\................../...).
. \....\................/.../..
...\....\............../.../...
....\..../´¯.i.¯`\./.../....
..../... I....i..(¯¯¯`\.....
...i.....i....i...¯¯.\...\...
...i.....i´¯.i´¯.i..\...)...
...\.....` ¯... ¯ ´......'....
.....\_buttrock_·´.....

interested in the DLS components, PM me about them when you get a chance...

Tempting bud...

I hear the installer was a big dousche ;) (this guy)

To clarify, I installed those components with salvia.d. I was just making a joke.

Great system. I had a blast installing it, and they sounded sooo good as soon as we turned them on... even before we adjusted them!

word, thanks for the backing. they were a lot of fun installing if you enjoy doing a system that isnt done much. they are super adjustable which makes it nice if you really want to tune them in for how you personally like it.

SPECS for those asking:

http://www.dls.se/en/car/prod.html?produkt=en_72

DLS UP35's. 3-way components

Tweeter UP1C, 28 mm (1,1") silk dome tweeter
Crossover Filter box with 12/6/6 dB slope
Woofer size 13 cm (5,25")
Midrange size 63 mm (2,5")
Power handling capacity 120 W RMS / 180 W max
Frequency range 60 - 20.000 Hz
Crossover point (Hz) 450 Hz / 5500 Hz
Sensitivity 89 dB (1W/1m)
Outer diameter of woofer Woofer: 130 mm (5,12") Mid: 100 mm (3,94")
Magnet size 62 mm (2,44") Hybrid ferrit/neodymium
Mounting depth Woofer: 63 mm ( 2,48") Mid: 25 mm (1")
Mounting hole Woofer: 120 mm (4,72") Mid: 82 mm (3,23")

WHY are these components so unique?

- The e36 3 series is the ONLY vehicle that these were made for without going with a completely custom setup. They fit in all stock speaker locations so it makes mounting easy with very minimal adjustments that can be done with a file or dremel. Working on mounted pics.


DLS A7 amp

RMS output per channel at 13,8 volts, 20 Hz - 20 kHz , < 0,1% distortion.
Mode : AB
Number of channels : 5
Nominal power in 4 ohm : 4 x 60 W
Nominal power in 2 ohm : 4 x 100 W
Mono channel, nominal power in 4 ohm : 300 W
Mono channel, nominal power in 2 ohm : 440 W
S / N ratio, A-weighted : > 100 dB
Damping factor : > 200
Input impedance : > 10 kohm
Input sensitivity, variable : 0,3 - 7 V
Filter ch. 1 & 2 : Highpass: 80 - 400 Hz / 1,6 - 8 kHz (x20)
Filter ch. 3 & 4 : Highpass: 80 - 400 Hz. Lowpass 0,3 - 4 kHz / 3 - 40 kHz (x10)
Filters mono sub channel : Lowpass: 50-125 Hz.
Terminal for external cooling fan : Yes
Phase control : 0-180 degrees continuously
Remote sub level control with phase shift : Yes
Dual DC-inputs : No
Current draw, idle : 1,1 A
Current draw, maximum : 120 A
Dimensions W x D x H : 605 x 240 x 73 mm (23,82 x 9,45 x 2,87 inch)

Are the DLS components still available???

The UP35s are sold I assume? If not, I'm very interested. I'm in southeast PA.

Thanks,
Paul

I'm very, very interesed in the 3ways as well... and pics of them installed if you would be so kind. :D


...even if they are sold already, can you send me a picture of them installed, I'd like to see how they turn out. I might just have to buy a set of these if it retains that stock look...

TIA
-Jon

Hey Jon,
I found a thread with some nice installation pics in the Audio and Electronics forum.
http://forums.bimmerforums.com/forum/showthread.php?t=806412&highlight=DLS+UP35

They really do look stock, but i would have liked to see the work involved. Apparently, it's pretty easy, just a little bit of time and effort with the Dremel.

BTW, I used to own a 97 VW GTI VR6 (Driver's Edition-Jazz Blue). I find the M3 to be rather reminiscent, but better!

-Paul

Awesome Paul, thank you very much for the link!

I hear ya on the M3 being better than the MK3 GTi, but they are both still fun in their own ways. I love the sound the VR puts out!:)

Thanks again!
-Jon

Hey Jon,
I found a thread with some nice installation pics in the Audio and Electronics forum.
http://forums.bimmerforums.com/forum/showthread.php?t=806412&highlight=DLS+UP35

They really do look stock, but i would have liked to see the work involved. Apparently, it's pretty easy, just a little bit of time and effort with the Dremel.

BTW, I used to own a 97 VW GTI VR6 (Driver's Edition-Jazz Blue). I find the M3 to be rather reminiscent, but better!

-Paul

I found another thread with great install pics of the up35. Shows what to cut and everything.
http://forums.bimmerforums.com/forum/showthread.php?t=588762&highlight=harness+up35
Bottom of the first page and top of the second. The guy is quite thorough.

-Paul

Very interested in the bsw sub... shipping to portland 97220?

updates from the OP? I'm interested in those components if they're still around.

Haven't heard from the OP at all.:(

Still interested in the components as well....

Still interested in the components as well....

Roshambo you for them...i go first of course

Roshambo you for them...i go first of course

Haha, that's funny. How about Russian Roulette? I get to load the gun though!:D

Haha, that's funny. How about Russian Roulette? I get to load the gun though!:D

I'm ok with that as long as I get to provide the rounds :devillook

Touche' :)

First of all. Sorry to those who were interested, i was without computer access for a LONG time and i ended up deleting my whole inbox so lets start over.

Now i have pictures and i'm ready to get these sold!!

Prices on components and amp are pretty firm.

^^^

you have a PM

Pm replied.

Still avail.

Pm replied.

Still avail.

PMed again.

wanting the bsw and sub. pm me...

pm sent.

sale pending on components.

how good are the bsw subs? i have been debating getting these for a while but cant justify their price online

not sure on DLS subs, never listened to them.

go with IDQ if you want a sound quality sub w/o the HUGE price.

Sale still pending on the components.

Amp and sub go up on eBay next week.

http://www.we-todd-did-racing.com/thumbs/large/1050028_6baoj/a7close.jpg (http://www.we-todd-did-racing.com/view/full/1050028_6baoj)
http://www.we-todd-did-racing.com/thumbs/large/1050029_lgikn/a7connects.jpg (http://www.we-todd-did-racing.com/view/full/1050029_lgikn)
http://www.we-todd-did-racing.com/thumbs/large/1050030_dntox/a7whole.jpg (http://www.we-todd-did-racing.com/view/full/1050030_dntox)

here are the pics of the amp.

amp is up on ebay. Search: DLS a7

2 days left!!!

$495 gets it.

Received 3-ways, thanks! they look great. I cant wait to put them in. Bump for an honest seller

If you need, search for the guy who did a complete write up on how to install them.

Make sure you take your time, and enjoy my friend :D

http://forums.bimmerforums.com/forum/showthread.php?t=588762
Heres the write up

pm'ed about amp

comin' back at ya.