I ran the peake faults code and came up with code....dE

"Time to closed loop temperature too long"

Can anyone tell me what this means????

Thanks!!!

It probably means your thermostat isn't operating correctly.
That's stricty a guess, mind you.

thanks,

Just how much does a thermostat run on a e36???

This could also be a bad temperature sensor. I cannot remember now if the computer and the dash display use the same sensor or not. Does your dash gauge register correctly?

-Tom

Originally posted by flea7
I ran the peake faults code and came up with code....dE

"Time to closed loop temperature too long"

Can anyone tell me what this means????

Thanks!!!

You can go to the Peake research site and under tech support, send a email with your question and get a reply. Be sure to provide all the detail on your car year and model, etc.

the temp gauge reads just fine. The needle is just below half way during idle and when cruising on the freeway the needle falls in the end of the blue. ....it's chill in seattle!

thanks for all the help!