danno14
02-04-2003, 12:06 AM
I had a previous post looking for a place to have some dyno work done. I Was referred to CarbConn in Kirkland http://www.carbconn.com/index.php3 . A copy of my previous post
(on DTM) is below. I have had a few people express interest so far, but not enough to make a go of it. Anyone else interested? Dan
I think I know where this place is! I work in retail so my weekends are at a premium (read=rare). With enough advance notice I could probably pull it off. The dilemma would be getting both cars there- my girlfriend works weekends too. Maybe I will do one car sooner and the other later. I have spoken with Alex at CarbConn and he told me the rates and available Saturdays: Feb 15, 22, Mar 8, 15 are open. If we can get people in for a weekday run it would be much easier. Club day rates are: $65 per car, $10 air/fuel readout. This compares to a normal rate of $95 per car, $50 air/fuel readout. It takes roughly a half hour per car; maybe less depending upin how hard it is to strap it down. How about a poll: Reply via pm if you are interested and note weekend, weekday or either. Dan
(on DTM) is below. I have had a few people express interest so far, but not enough to make a go of it. Anyone else interested? Dan
I think I know where this place is! I work in retail so my weekends are at a premium (read=rare). With enough advance notice I could probably pull it off. The dilemma would be getting both cars there- my girlfriend works weekends too. Maybe I will do one car sooner and the other later. I have spoken with Alex at CarbConn and he told me the rates and available Saturdays: Feb 15, 22, Mar 8, 15 are open. If we can get people in for a weekday run it would be much easier. Club day rates are: $65 per car, $10 air/fuel readout. This compares to a normal rate of $95 per car, $50 air/fuel readout. It takes roughly a half hour per car; maybe less depending upin how hard it is to strap it down. How about a poll: Reply via pm if you are interested and note weekend, weekday or either. Dan