4 16x8.5in kosei k1's custom drilled for a e30 bought as blanks from tire rack and they drilled them. 27mm offset so spacers might be needed, they were for the track and I ran 245/45/16 toyo ra-1's on them with some custom spacers in the front (22mm) and 5mm spacers out back. Not sure what would be needed for your car like I said these were on my old race car.
Hub bore is 72.2 drilled. Paints pretty good but some scratches on them due to track use no gouges or anything bad. When purchased new they were $225 each and I would like to get 500 for all 4
heres a pic of them on my old car more pics tomorrow.
http://memimage.cardomain.net/member_images/6/web/402000-402999/402245_11_full.jpg

You were running 22mm spacers up front?!?

These are 4x100 right?

Oh, also, more pics would be great...and can you weigh one?

Thanks!

Ben

pm me your email address for pics, ran large spacers to clear the 245's and yeah they are 4x100 with e30 hub bores. we cleaned them up and there are actually in amazing shape look almost new. Ill try and weigh one today

Did you have to roll or tweak the fenders to make them fit? What year E30 was it from? I've heard that the pre-88 had larger wheel openings.

it was a 87, had to roll the fenders a good bit but didnt pull them all that much. Fit in the rear on my car was easy but cant see it being to hard on a later car just a little more roll. I also didnt run super low which helped a bunch.

just checked and there were 17mm spacers up front on my car so most likely wouldent need much bigger then this

http://s135.photobucket.com/albums/q129/vodomagoo/16in%20K1/?action=view&current=1175544632.pbw
pics of the wheels, show the only real damage to them toward the end (1wheel has a nick on the lip)

weights are around 16-17lbs