Okay, if I have the following and NOTHING else:

2 x Alpine 12" Type-R subs
1 x Rockford Fosgate P8002 Amp
1 x Ported Sub Box
1 x Line Out Converter

What else do I need to buy in order to hook this thing up to a stock HU.

I know VERY little about car audio, so speak n00b and be very specific about what I need to buy and list literally everything I need no matter how obvious...

Thanks

Hayden

Hayden,

You will need some solder, soldering gun, heat shrink tubes of various sizes, electrical tape, wire cutter, wire stripper, crimping tool, speaker wires, ring connectors, sand paper, philips screw driver, flat head screw driver, panel remover, flashlight, factory radio removal tool(some sort of hex driver or allen wrench MIGHT work), power wires, RCA's, 13 screws, a couple hours, a wiring diagram for the factory amplifier, a wiring diagram for the P8002 amplifier, a wiring digram for the Hype R's, zip ties, digital camera with a memory card and batteries.

I may be missing something.

-Chris



*EDIT* Spade connectors, incase you have speaker terminals on the enclosure.

-The 13 screws is incorrect. It will be 21. 16 for both subs, 4 for the amplifier, 1 for the ground.

If you are total noob then I would also consider shelling out around $100 to get it professionally done while you watch. Amps, subs, LOC.

If you are total noob then I would also consider shelling out around $100 to get it professionally done while you watch. Amps, subs, LOC.

I think that's what I'm going to do haha