These were from the Ground Control Race kit used on my BMW M3(E36).

I have two pairs:


450lbs spring rate (600-250-450) : $75 shipped SOLD to user "todor" on 2/23/2007
650lbs spring rate (600-250-650) : $100 shipped SOLD to user "Infini IV" on 3/09/2007


See pics attached. Post here, or PM me or e-mail.

Gio

Interested, How much would these drop my car... I have H&R sport springs and my car is low Enough I have 2 inches clearance for part of my wastegate and turbo downpipe... So just can't go any lower.
but i am looking for Progressive Springs Oh ya this is for a E36 328is

Interested, How much would these drop my car... I have H&R sport springs and my car is low Enough I have 2 inches clearance for part of my wastegate and turbo downpipe... So just can't go any lower.
but i am looking for Progressive Springs Oh ya this is for a E36 328is

I know they will lower the car (based on the spring perch and where you have it set), but I can't tell you how low.

Gio

Interested, How much would these drop my car... I have H&R sport springs and my car is low Enough I have 2 inches clearance for part of my wastegate and turbo downpipe... So just can't go any lower.
but i am looking for Progressive Springs Oh ya this is for a E36 328is

Jordan these are not progressive rate springs. They are race springs of 2.5in inner diameter, which need appropriately sized spring perches usually found in race coilover suspensions. If you have H&R sport or race springs with stock spring perches, these will not fit.

bump

bump

these wouldn't fit a 318is, would they?

these wouldn't fit a 318is, would they?

Not sure as you'd have to ask Ground-Control. These are for 96-99 BMW M3 (E36).

450lb set sold to me! Just sent payment through paypal. Thanks.

Thanks Todor. Got the PayPal payment. Will ship out tomorrow morning and send with confirmation number.

The 650lbs springs are still available.

The 600lb springs are still available.

wouldn't fit 96 328i would they?

wouldn't fit 96 328i would they?
Just so everyone knows, these springs fit only coilovers or other modified (racing) suspensions that take 2.5"-inner-diameter springs. They do not fit the stock suspension on any BMWs without additional parts such as spring perches, adjusters, etc.

On a different note, this is a great seller and I recommend him to everyone!

wouldn't fit 96 328i would they?

Read the buyer (Todor's) response to your question. That's the answer.

Thanks for the comments Todor.

Again these springs are from the Ground-Control race setup.

Gio

Sent you a PM. I'll take the remaining pair.

Sent you a PM. I'll take the remaining pair.

SOLD to Infini IV.

Thanks,
Gio