ebydrc
12-05-2006, 07:47 PM
the following is for sale and prices do not include shipping pics will be posted within the next few days. PRICES REDUCED
42lb green top high impendence injectors x6 -200usd (used only to tune the car and were taken out and replaced with 65lbers ;))
greddy emanage blue with engine harness -220usd
AA 2.5" uppipe -SOLD
4" flex intake tube measures about 2 1/2 feet long -20usd
Stock fuel rail -20usd shipped
beat up dinan 4" intake filter -20usd
misc. brand 3" cone intake -15usd
4" - 3" turbo hoses reducer -25usd
s52 manifold tapped with two 1/4 barbed fittings -65usd shipped
corbeau D159t double locking sliders for driver and pass . -30usd
heres those pics
turbosporttsi
12-07-2006, 02:25 PM
are you seriously selling a 2.5" mandrel 90 degree bend for 70 bucks?
TC535i
12-07-2006, 02:56 PM
are you seriously selling a 2.5" mandrel 90 degree bend for 70 bucks?
There's another bend at the end there, plus the ends have beads on them to hold clamps better... :dunno
ebydrc
12-07-2006, 04:42 PM
are you seriously selling a 2.5" mandrel 90 degree bend for 70 bucks?
no its more like a 45- straight 90- straight 25-. its made for AA intercooler because the intercooler end tanks they use are angled instead of straight out. the price is very negotible ;)
JordanMD88
12-07-2006, 06:58 PM
For the 4" intake piping, do you know how much heat that can take? Would it be safe to smush it aginst my manifold to put my air filter where the washerfluid resevour was?
ebydrc
12-07-2006, 07:14 PM
For the 4" intake piping, do you know how much heat that can take? Would it be safe to smush it aginst my manifold to put my air filter where the washerfluid resevour was?
im pretty sure it would work you might want to wrap it, if your manifold is wraped or coated i would think it would be fine, ive seen what your talking about done with this stuff before.
turbosporttsi
12-08-2006, 04:48 AM
no its more like a 45- straight 90- straight 25-. its made for AA intercooler because the intercooler end tanks they use are angled instead of straight out. the price is very negotible ;)
hmm... i wish i could see it person on a car. it may or may not work with the FMIC plans i have. i'll keep it in mind though. flexible price + multiple bends = not bad. :)
95RogueM3
12-10-2006, 01:39 AM
42lb green top high impendence injectors x6 -230usd (used only to tune the car and were taken out and replaced with 65lbers ;))
How negotiable is this? I am tempted to buy them, but a new set isnt too much more (I understand yours arent too far from new...) :)