Just posting some pics of CerealKilla's ECU - it's all done and I think the wiring is about as clean as can be for GM wasted spark coils, 4 Bar map sensor with baro correction, etc.

http://blowneuroz.com/mygallery/E34%20535i%20MegaSquirt/kevms1.jpg

http://blowneuroz.com/mygallery/E34%20535i%20MegaSquirt/kevms2.jpg

http://blowneuroz.com/mygallery/E34%20535i%20MegaSquirt/kevms3.jpg

Fairly clean. That's the expansion board I got by the way - it supports EGT input, knock sensing, 2nd VR circuit (cam sensor) input, shift lights, launch control, etc.

Is this based on PCB v3 or 2?? (Im pretty unfamiliar MS so I may be wrong with names)
Also, how does the 4 bar map sensor come into it?? Can you explain a bit more about this setup please. Im curious.
good work too

Looks good, I would clean the flux off the back of the board.

Cool, is this a plug and play unit?

Looks good, I would clean the flux off the back of the board.

Yeah I wash it before it goes in a car.

Its a MS-I v3 that will run MSnS-E firmware. The 4 bar map sensor is the small hose on the underside, it is excessive (4 bars!) but offers baro correction, so that's why we went with it.

:buttrock Now to finish wiring in the harness and some non fouled plugs.