I was going to go to Home Depot and build one, but if anyone has one (either the Victory design or any homemade version) and you're local, I'd like to borrow it!

I'm planning on doing this today so if anyone has it let me know ASAP! Thanks.

Damn I went to 2 hardware stores and they didn't have the proper stuff to build something like the victory design tool (home depot and fishers in springfield). Advanced auto didn't have the right tool for rental either.

home depot sucks. They never have what I'm looking for and it takes me an hour to figure that out.

home depot sucks. They never have what I'm looking for and it takes me an hour to figure that out.

Yeah but I figure they would have 8" of threaded bolt about 3/8" in diameter, and a few other things...but nooooo

They better have the parts for my camera mount tomorrow. There are zero alternatives in Tallahassee, I'm sure.

home depot sucks. They never have what I'm looking for and it takes me an hour to figure that out.

+1

What RTABs are you putting in? If youre just putting those powerflex ones in, they just press in. Cut the old bushing out. a 1/2" piece of threaded stock with thick washers and bolts ought to work. 3/8" is sort of a rare size.
Peter

What RTABs are you putting in? If youre just putting those powerflex ones in, they just press in. Cut the old bushing out. a 1/2" piece of threaded stock with thick washers and bolts ought to work. 3/8" is sort of a rare size.
Peter

I think a half inch is too big...took the powerflex ones in and the 3/8 had a bit of room, which i guess is fine. The casing bolt on the RTAB isn't 1/2" either I don't think, but I could be wrong.

I do think I'm just going to drill/cut the old ones out, just need to make the time.