Ok,
So, I may be going another route yet again. I have no time to tune this car on my own so I think I'm canning the emanage again. Nothing against it, it's great and my cars starts and idles very smoothly with it and drives fine; I just don't have time to tune at the moment.

What's included (all less than 30 mins of use on them):

Emanage Ultimate unit $514
Ultimate Harness kit $93
A/F sensor input harness $25.75
Greddy Pressure (MAP) sensor $102
Pressure sensor harness $31
Greddy Emanage Software - Included
USB cable $5

Total cost new (from cheapest place for Emanage online, Mohd Parts):
$770.75 + 15 shipping!

I'm asking $690 for it in what is basically new condition...I just need to get rid of it and get some money back so I'm taking a loss.

Optional: 3 series DME (works with my M3, would work with other 3 series with a proper chip, I can include a chip for the M3 that will make it work w/o aligning EWS) with ignition part already wired in (only way to run ignition tuning on our cars with emanage)


For the DME that is wired to work with the emanage (will plug right into the harness!) I'm asking $200, which is probably the price you'd pay for a totally stock DME anyway!

Serious inquiries only.

Thanks,
Nick

Oh, and I forgot, it also has a special resistor box required for BMW's so there's no Check engine light. I paid $30 and asking $15 for it.

No interest?

No interest?

I am. pm'd you.

i'm interested if ^^^ he doesnt get it.

i'm interested if ^^^ he doesnt get it.


Thanks, I'm trading PM's with him now, so I'll keep this updated.

OK,

Still available, the other guy wanted just parts of it, but I'd like to sell it as a whole.

will the resister box work with odb2? what cel does it prevent?

will the resister box work with odb2? what cel does it prevent?

Yes it will because the guy that makes them uses one on his obd2 car. Without it the DME thinks the injectors aren't there and throws a CEL for missing injectors basically. This just gives proper resistance to make it think nothing has changed.

STill for sale, no one says they'll take it yet!

So 890 for the whole setup? With ECU?

So 890 for the whole setup? With ECU?

That is correct, and if you have a stock 413 DME to exchange, I'll knock $100 off the price of the modified DME.

Thanks,
Nick

BUMP for a good guy :)

Thanks Jordan..still for sale!

Pics:

All the parts (minus DME)
http://filebox.vt.edu/users/nicolasb/Random/M3/For%20Sale/Emanage/emanagestuff.JPG

Neatly modified DME with plug in for ignition wiring (easy to remove, and install!)
http://filebox.vt.edu/users/nicolasb/Random/M3/For%20Sale/Emanage/emanwires4.JPG

How it looked installed! Very clean and stealthy, no wires all over!
http://filebox.vt.edu/users/nicolasb/Random/M3/For%20Sale/Emanage/DSC02817.JPG

ttt