how do you guys with gt35r's route your charge piping? i want to run my piping above the subframe along side the intake pipe because of questionable local roads. i had a 90 degree tight radius elbow welded onto the compressor outlet and had as much of the outlet cut off (without actually going into the compressor housing) but it is still not enough to quite clear the subframe. to clear it i would need to cut more off the elbow and have a tight 90 degree bend to get up and over. are all these bends going to significantly compramise the flow or should i just run the piping under the subframe and possible have to repair/replace it much more frequently?

come on, lots of guys here have this setup:(

I have that setup, but mine is below the subframe...