I'm looking at getting some H1s and I was wondering what is all required to get them mounted and wired up. I assume it's just like replacing the sealed beam, but the wiring is what I'm a little worried about.
TIA,
Jake

I have a H1 and H4 Bosch E-code set-up that I'm going to be selling. I didn't wire them up so Not real sure the exact wiring but I can include all of it. They work great but one off the low beam lenses has a crack in it. Not sure what the price is but I'l do some investigating.


Jay

H1's need a power wire that is connected to a swith and relay. You have to ground the housing of the headlight to the body. Only 1 actual wire plugs into the H1 bulb. Or you can use the wires from the fog lights if you still have them.

I took the foglights off, and I couldn't find the source of the wires, so I just snipped them.
Jake

If you order them through Susquahana Motorsport you get the wire and connectors with it. It was real easy to connect.

If you order them through Susquahana Motorsport you get the wire and connectors with it. It was real easy to connect.

yep.

What is your intension with the H1's. If you are wiring them like highbeams then its a plug in. If you are wanting them to act like fogs, or have 4 running lights then its a lil different route.