if i ran a stage 2 s/c with software that was not written for schrick cams? the software is written for the stage 2 but not with the cams.

prob. not so good...

those schricks have, i think, around ~1.2-1.5mm more lift.
More air = a bit more lean up top in the RPM range?

i would e-mail one of the many tuners on this site and get there input. It might run, but not as well as it could.

Why not get it tuned? Better to play it on the safe side and not risk anything. Although I do think that they make software for it. Ask JimM3, i think thats his name, from KO I'm sure that he has the software and even sells the cams. Just my 2cents.

-Dave

i obviously wouldn't drive hard that way. but basicly would it be good enough to "pu$$y foot" it to get tuned.

your OBD-I... just have a chip burnt and sent to you when you install the cams.

There are people out there already running this set-up. just PM them and ask the 'who, what, where' about the software...

the hardware should be easy.