Don't know if this is the best place for this question, so forgive me if I should post it elsewhere. Lot's of posts for specials on Xenon kits and figured someone would have the answer.

Over a year ago I bought an Xtec kit from (I believe) Mr Clam. Busy times, etc and I am just now installing.

The harness for the buld consists of three wires that go through the rear cover. Two of the wires go to a connector to the ballast the third wire connects to something?? in the headlight housing and the other end connects to ???

Any help is appreciated! :help
Bill

Could you take a pic? I have XTEC bulbs and I only have 2 wires...

First pic is the wiring.

Second is the schematic they supplied. My confusion is where the Xenon's get their + power from since it shows it from the 'inside' of the headlight.

Never mnd, I figured it out. The (+) inside was the 'old' yellow positive to the old bulb. Works fine!!