I recently purchased some HREs and all the rims fit perfect except the rear. They are 18" rims w/ 255-35s. It doesn't rub on the outside near the fender, but instead it rubs on the inside of the wheel well only in one spot. So I was hoping you can all help me out. Should I hammer or shave off some of the inside so the tires can fit or take it to a shop and do it right? If you recommend a shop. Where is a good place which does a nice job and also does it for a decent price. I also will be rolling the fenders when I get the inside done. So please if you can help I would appreciate it very much, thanks.

goddamn iranians. use some spacers and roll the fenders.

yeah, but they are not as bad as persians, right pasha?

same shit man. fuckin persians with their beh emm veh's

yeah...and their Ali G's

I don't want spacers, but if that's what you all recommend then alright. Also why do you think I'm Persian/Iranian?

kourosh joon, its ok. i can smell the armani a mile away...g

use some spacers and roll the fenders.

Shaving off "some of the inside" sounds sketchy.

Shaving off "some of the inside" sounds sketchy.


i love how people who own HRE's think they're soooo much better than the rest of us. stupid elitists :shifty

i love how people who own HRE's think they're soooo much better than the rest of us. stupid elitists :shifty


Be quiet Pasha. Give me your E30 door pockets.

i love how people who own HRE's think they're soooo much better than the rest of us. stupid elitists :shifty


LOL! Your right I do where Armani Acqua Di Gio...good guess, hahaha! Also the HRE's which I have were a good price so I picked them up. I still want the Fiske FM10s in 18s, but these were too good to pass so I picked them up. If I ever see the FM10s on this board for sell I will pass up the HRE's probably. So you can buy them from me and "be better then the rest of us" :D

koss mikham