I just picked up a used Borla setup from one of the board members. Do I reuse the stock mounting hardware or do I have to buy some hangers and bolts, etc? What is this "hose clamp" trick I've been hearing about to correct the sagging right side tips?

I just picked up a used Borla setup from one of the board members. Do I reuse the stock mounting hardware or do I have to buy some hangers and bolts, etc? What is this "hose clamp" trick I've been hearing about to correct the sagging right side tips?

stock mounting hardware is used for borla... when you take off the stock, you'll see where it all makes sense..

Hose clamp fix isn't necessary if you tighen the clamps good enough.. it's posted somewhere on how to do it..

Ok. I remember you telling me that last week, but then I saw two different posts on other boards where people said they needed to get extra nuts and washers. Why, I have no idea.

I'm going to go crawl under the car right now and take a look. Did you pull the rear valance off when you did the install on your car?

http://www.fastm.com/M3/Exhaust.html

I do recommend to have a friend help out for any assistance.

Thats an excellent guide, Jon. Thanks.