View Full Version : Tans mod Fail Prog


BimmerBaby
12-17-2003, 01:07 PM
or something like that is being displayed....whats this mean i looked it up and didnt really get much outta it.:dunno any insight? also i am a moron and tried to post of roadfly but apparently it didnt show up. i cant work that site at all. Also i tried to register at clube31 but i couldnt 404 error kept coming up.. i know not many people frequent this area but TerryY? any help?Thanks
Worried,
Vaishali

ajw45
12-17-2003, 04:13 PM
Don't worry, a day from now like 4 copies of your post will show up on roadfly :D As far as I can remember, what you're getting is a generic engine electrical fault. I know, that's no help, but neither is the error. While it refers to a fault putting the tranny in safe mode, the cause is often hard to figure since it could be anything. Have you done anything to the car recently? How are the batteries? It is very common for weird things like this to be caused by week and dying batteries. Try searching for "trans fail safe" in roadfly. You'll get everything from plug wires to air filters but its a start.

Good luck!

TerryY
12-17-2003, 10:06 PM
When do you get it and what happens when it comes on?
Does it reset when you restart?
Is your display hard to read because of missing lines? Display is Fixable cheap.

Keep us up to date

Oh BTW-When you log in on Roadfly make sure he little box in the login window is checked or nothing works.

BimmerBaby
12-18-2003, 01:25 AM
Thanks for the replies...
ajw- i have not done anything to the car besides wash it :) as for the batteries...the car is driven every few days or so...

TerryY- all the lines of the display work. The weird thing about it that sometimes the message displays and the car drives like its hauling a ton of junk and other times it doesnt display and the car is zippy...

Also, the triangle with the circle around it and the exclamation point inside lights up ( i hope you all know what I'm talking about since im using so much technical jargon :stickoutt )
Thanks for all ur help guys! what do u suggest i do?
~Vaishali

TerryY
12-18-2003, 02:25 AM
The transmission is in limp home mode when the light is on. It locks itself into one of the higher gears 3rd I think and doesn't shift at all.

Thre should be a code to read but you need a code reader to get it and other than the dealer I'm not sure who else might have one. Try calling the local independents and asking if they can read transmission codes on an E31 or E32.

The triangle with the circle should be the traction control light. It flickers on when the traction control is doing it's thing.

If the light is on all of the time then either the ASC switch on the center console is stuck down or the traction control system is faulting during self test (Broke).

BimmerBaby
12-18-2003, 11:20 AM
hey terry
the light is constantly on while driving, tho when i looked up the message in the owners manual it mentioned something about the light staying on and not going off after start up (one of the few things that I did get out of reading that.) anyways, I have a couple of phone calls to make around here i suppose. I will let you all know what happens.

TerryY
12-27-2003, 12:42 AM
Find the problem yet?

Check the plug that connects to the air sensor between the air cleaner and the engine too. Just had that problem on the 740.
Gives Trans Prog if it is loose!!

BTW I have a couple of sets of "Inexpensive chips"
if yours is a pre OBD2 car (mid 95 build or earlier)

I believe that they are far better than Dinan chips and probably come close to the Conforti. Euro chipper claims 320 hp from the V8. After the Dinan that was in mine (296 hp claimed) it certainly feels like 320 on the butt dyno and it passes German emissions testing.

BimmerBaby
12-27-2003, 02:01 AM
Hi Terry,
I just have been so busy with work and the holidays that i havent been able to get the my poor baby. but i did check the batteries and they were ok. Now my next step is to yank that sucker out :) hehe
as for the chips i would be very interested for my birthday is on the way. In a thread that i put a few months ago when i first register i asked you about them i remember. Where did i have to look for the date again? in the car door sill? Id be very interested.
TIA,
~V~

TerryY
12-27-2003, 02:45 AM
Check that connector by the air cleaner box before you rip anything out. And start the car twice after any change you make. It may not clear on the first try!

The 840 chip is $100 and if it doesn't make it go noticeably better I buy it back.

The sticker is on the back end of the drivers door.

The build date is the date at the upper right like 05/94 on this picture from mine.

BimmerBaby
12-27-2003, 06:18 PM
ok so i checked the build date and it says 6/95 thats mid 95 build right :)
~V~

TerryY
12-27-2003, 10:16 PM
I think it should work.

BimmerBaby
01-03-2004, 02:22 PM
Id be very interested. Is there a college student discount? lol jk Yes, my birthday is in the first week of feb. so my father would proabably like to buy one in the next few weeks.
~V~

TerryY
01-05-2004, 10:04 PM
It could probably be arranged. Paypal? or?

BimmerBaby
01-06-2004, 09:00 PM
yeah i have paypal :)

TerryY
01-06-2004, 09:39 PM
E-mail me when you are ready.

BimmerBaby
01-06-2004, 09:45 PM
yeah thatll probably be in a few weeks... thanks :)
till then
~V~