hey you guys, i was wondering if any of you out there with the gruppe m intake had any problems after you installed it. I followed all the instructions but when i started up my car the check engine soon light came up. :bawl. What should i do?? any help would be greatly appricated. Thanks!

-eric

Check the HFM... quite possibly not hooked up correctly.

I agree with Kevlar. The HFM sensor could be installed backwards. `

humm gonna go check on it right now, thanks mucho you guys!

well i checked it again and i moved it around but the service engine light was still on. :bawl there anything else that might be wrong with my how installed the intake?

If you have corrected the condition that caused the fault, it still will not turn off the check engine light. You will have to go through several drive cycles where the DME dose not see any problom with the HFM sensor before it turns off the CEL, even after the CEL gose out the fault will still be stored in the DME for 43 clean drive cycles. :confused:

Originally posted by Beavis
If you have corrected the condition that caused the fault, it still will not turn off the check engine light. You will have to go through several drive cycles where the DME dose not see any problom with the HFM sensor before it turns off the CEL, even after the CEL gose out the fault will still be stored in the DME for 43 clean drive cycles. :confused:

We have some pretty sophisticated ECU's