I am thinking about SSR GT3 staggered setup, 18x8.5 front, 18x9.5 rear. I can't seem to find any offset infos on tirerack.com.
Is it possible to fit these wheels on a 95 E36 M3? With the fenders rolled already.

I have a 98 m3 with 18 x 9 - 44 mm offset and 255/35/18 SO3. I have a small amount of rubbing on the inner fender wall. The outer fenders are rolled. I can't see fitting 255/35 on a 9.5 inch rim without some rubbing. My car is also lowered one inch. This set-up might work if you use a smaller size tire. 245?

They do make the wheel for the car but you will need to do some modification to make it work. You would need to run a little more negative camber and probably roll the fender lips.
If I can help let me know.
Thank you

I have the same setup you want to run... 8.5" ft w/ 225/40 S-03's, 43 MM offset, 9.5" rear w/ 255/35 's, 43 offset. My rears are mildly rolled and I run coil overs pretty low, no issues for me. You may need a 2-3mm spacer in the front depending on which strut housing you are running.

Thanks for all your suggestions/inputs!
I am running the FK Konigsport Coilover with 10mm spacers in the front, fenders already rolled in the rear. :)

I dont know if you will be able to run a 255 in the rear of a sedan. i have ssr gt3's with 43 offset running toyo proxies 245's and i have about a finger between the exhaust and the tire. if i can run a 255 please tell me how...

Alot of negative camber :D
I haven't find any other ways......just be prepared to go through 2 new rear tires every 6 months