Does anyone have an old thrust arm and/or track control arm lying about? I am considering manufacturing some of the unavailable balljoint seals in thin polyurethane to save the arms where these rubbers have split during arm removal or simply age.

I need the old rubber taken off and the diameter of the outside of the ridge it fits on and the diameter of the pin where the seal sits, yes I know its tapered but approx where the seal will need to sit.

Thanks in advance,

8Tech.

PS, probably will not bother with roll bar drop link seals or trackrod ends as these are cheap enough to replace anyway.

I have one I will get you the measurements tomorrow I had tried looking for the replacement never could find one

Exactly my reason for manufacturing them!

That would mean that I would not have to buy a new thrust arm but just the stuff from you if it needed replacement?

Yep!

Great post! Any time frame on the adjustable camber plates Gerry? I'm hurting and don't want to raise the car, I'm holding out until they're done, Just curious, Thanks!